Symptoms of a Bad ATV Starter Solenoid 2023
How to tell if Starter Solenoid is Bad on ATV?
There is a significant probability that the starter solenoid will be at fault if your ATV is giving you problems.
Identifying the exact source of the issue and determining the best course of action might be challenging.
To learn more about your ATV and how to spot a starter solenoid problem, read the information below. After reading this, there’s a very high chance your ATV will function normally once again.
Overview of a Starter Solenoid
A switch known as a starter solenoid establishes a point of contact between the battery and the starter. The coil becomes activated when the starter button is pressed.
As a result, a contactor is pushed, completing the circuit and sending direct current (DC) current from the battery to the starter. The starting solenoid also contributes to a steady start-up.
The starter solenoid of an ATV is typically found on the frame. It is usually located on the outside of the plastic, next to or below the battery, close to the wiring harness.
You are often looking for a square or round mechanism with two little and two large wires attached, though their shape and size can vary.
How to Detect a Bad ATV Starter Solenoid?
You have probably experienced a starter solenoid issue as an ATV owner at some point or another. We regret to inform you that if you haven’t yet, you most likely will at some point.
As a result, it is essential that you train yourself on how to spot a faulty starter solenoid so that you’ll be prepared to tackle issues as soon as they arise. Your peace of mind and safety depends greatly on this.
You may check your ATV’s starter solenoid in a number of different ways. See them down below!
Rule Out Any Battery Problems
It’s always a good idea to check your battery, even if you are reasonably convinced it is in good condition.
If you’ve never checked your battery before, you should absolutely learn how to do it. It is important to do this regularly.
Here are some clear symptoms that your battery is the problem and has to be changed right away:
- Lumps or bumps in outer casting.
- Broken or loose terminals.
- Cracks in the plastic casing become obvious.
- Burnt or melted plastic.
- Leaking battery fluids.
- The appearance of flecks or discoloration.
- Low levels of electrolyte.
For more assurance, you might want to test your battery. The starter solenoid should be the next thing you check if you are certain that your battery is not the issue.
Symptoms of a Bad ATV Starter Solenoid
A bad starter solenoid displays a few readily observable symptoms. Here are some indications that your ATV’s problem is caused by a bad starter solenoid:
1. The ATV Will Not Start
This is the most prevalent symptom that there may be a problem with the starter solenoid. Your starter solenoid may be broken if your ATV won’t start after you turn the key in the ignition.
2. The Starter Solenoid Will Be Making A Clicking Sound
This is a symptom that the starter solenoid is malfunctioning. However, a battery with insufficient amps is another major source of this problem.
Therefore, it would be worthwhile to perform a more thorough check of the battery if this is the only symptom.
3. The Starter Solenoid Refuses To Turn Off After The ATV Engine Has Started
The circuit ought to close after you press the starter button to start your ATV engine and release it. The starter motor should, therefore, no longer have power as a result.
However, if your starter solenoid continues to run after the engine has started, there may be a problem with the main contact of the starter solenoid.
It is likely that in the closed position, the major contacts have fused together.
4. Intermittent Problem Starting The ATV
The ATV may occasionally have trouble starting if a starter solenoid isn’t functioning properly. This can be the result of damage from debris, dirt, or too much heat.
After starting your ATV, the starter should turn on immediately.
Your ATV’s starter solenoid may need to be repaired if you discover that it takes several attempts to start it.
This may also be the issue if you are able to start the ATV, move it a short distance, and then discover that it stops working.
5. The Starter Solenoid Continues Spinning
This is a strong warning that the starter solenoid may have a highly dangerous problem. In terrible situations, the system may be damaged or even explode. As soon as you can, turn off your ATV and get off.
Frequently Asked Questions
How can I bypass the starter solenoid to start my ATV?
Locate the starter solenoid and the two main wires sticking out of the starter if you have to start your ATV with a bad starter solenoid. Jump these two wires to short-circuit the starter connections. Once this is completed, connect this short circuit with your ATV’s ignition. Your ATV should now start.
Can You Safely Bypass a bad Starter Solenoid?
While you could do this if necessary, doing it repeatedly could lead to issues. If possible, it is best to resolve the problem as soon as possible rather than risk further damage by bypassing the bad starter solenoid.
Are there any other issues that could lead to a bad solenoid starter?
Yes. If the starter solenoid you tested was bad, you might also want to look for these other issues.
- A faulty alternator.
- A faulty starter.
- A blown fuse.
- Corroded wiring.
Wrap-up
You can accurately identify problems with your ATV by being knowledgeable about the electrical parts of your ATV and knowing how to test the starter solenoid and battery.
It is crucial to resolve these problems appropriately as soon as possible to avoid the emergence of new issues.
To make sure your ATV stays in perfect shape and you are secure while using it, it is always a good idea to contact a professional to troubleshoot or fix the problems if you don’t feel confident doing it yourself.
